I'm in the middle of an engine swap (sorry, not a diesel, just a Hemi into a Dakota), and am at the point of sorting through the electronics. I ordered 2 schematics for the vehicles, and they are factory schematics. Neither has any diagrams of connector pinouts! They just show the origin and termination of the wires and color codes, but no connector info at all. Does anyone have any info about the bulkhead connectors on these vehicles? They are a '97 Dakota and an '04 Ram 2500.

Jim

 

Here's wiring diagrams for the '04....http://www.dodge.com/bodybuilder/

For the '97, I don't know where to send you.

HTH

Tony

 

Why don't you just look at the wire entry to the back of the connector to determine your own pin-out from the factory schematics?

 

The connector has so many wires, there are several of each color code. For example, 2 or 3 red with black stripe, a couple pink, multiple reds, etc. In order to know which is which, it would require tracing each back to its origin. Knowing the actual pinout would save many hours of tracing wires. Hopefully the link above will help...I'll know after a couple more night's of downloading. 32 meg is a big file for 36k dialup. Thanks for the link though!

Jim