Question

In the event one had an Edge Juice with Attitude Monitor already installed.
Would it Not be possible to Leave the Edge Set on Zero And Use it Strictly for Gauges?
Or would this conflict in Any Way with using the Smarty as the Actual programmer /Tuner ?

 

Yes this can be done. I had the Juice with Attitude when I first got my Smarty and left it there just for the gauges. I later removed it and have replaced the Juice with a TST R49. I do miss the Attitdue gauges, however, and am considering stacking it with the TST and Smarty.

 

That is how I have been running mine, works good for me.

 

Turn the Juice to 0 and it will work just fine. Just remember, if you start getting into high boost with a big single or twins, the Attitude does not read over 44 PSI.

 

I just stacked the Smarty with the JA last night. Haven't driven it much, but the test run was really good. Had the Smarty set to SW 2 (no timing) and the JA set to 1, 2 and 3 - all with excellent response, low egts and no apparent first run issues. So far, so good with my 2006.

Thomas