Just hooked up my new commander and everything seems to be good...except, the commander doesn't seem to be controlling my XZT. I can't tell any difference between any of the levels, including going from 0 to 3.

I bought my XZT new (from Ebay) about 6 months ago and the commander just last week.

Is there a way I can confirm it is switching levels (in case my SOP meter is off) or could this be a known issue with a fix out there?

 

Look at the LED on your module. Tell me if the LED changes colors with the power level changes.

 

I know it might sond stupid but I just have to buy a comander to actually be able to add more power to my XZT

Buzzman

 

ok I checked out the lights on the XZT and it is RED on levels 0 and 3
and OFF on levels 1 and 2.

 

Buzzman: Adding a Commander does not give you more power. You already have a 65hp module and with the Commander you get 2 additional lower power levels and an off position. So you end up with off-25-45-65hp, which allows you to set up defueling functions.

 

TTT for quad

 

So it is no power to gain by adding a commander . I was under the inpresion you could upload the 100 hp with the comander and put it in the XZT.


Thanks

Buzzman