I may sound really dumb here but where is the iat sensor located at and how can I resolve this code as I think its interfearing with my egt sensor. I just installed a quad commander and its only showing about 70 degrees at start up and I think its duee to the fault code. Any help would be VERY appreciated

 

IAT is located right after your air filter...it has two screws holding it down, and four wires going to it.

As far as the code, can't you erase it with your Smarty?

 

yeah I erased it but I'm still not getting an accurate reading on my commander for egt's

 

I am not familiar with how the commander works, so I can't help you with that...but I don't see how a IAT code will effect your EGT readings?

Assuming that you have the EGT thermocouple installed properly, it is possible that you have a bad probe or a defective Commander.

Hopefully somebody who has more experience with this product can chime in.