Engine miss at RPM
#1
Registered User
Thread Starter
Join Date: Mar 2002
Location: Nanoose Bay B.C. Canada
Posts: 748
Likes: 0
Received 7 Likes
on
7 Posts
Engine miss at 2200 RPM
I have a 2001.5 24v engine standard it has a miss at around 2200- 2300 if you hold it steady. I have a new injection pump and the fuel pressure is at 13lbs, and no codes. The only thing I can see is mechanical ( injectors ) going to change them out next week to see, they have been in for the last 9 years... so.. I have a new set of 120hp going in ( new body and tips ) any one run into this situation before? any ideas would help..
Last edited by Dieselbuilder; 04-08-2012 at 12:09 PM. Reason: rpm numbers did not show
#2
Is this the RPM that you normally drive, I have the same problem at about 60MPH and its been suggested to me that its the Throttle Position Sensor, I did have a big throttle issue 2 years ago and had to replace the TPS which solved that problem but I think I may need another one
#3
Registered User
Thread Starter
Join Date: Mar 2002
Location: Nanoose Bay B.C. Canada
Posts: 748
Likes: 0
Received 7 Likes
on
7 Posts
This is where I can realy see it but when driving you notice it most of the time, and yes I have a new timbo tps this is a nother thing i will reset when I install my injectors as well as a valve set
Thread
Thread Starter
Forum
Replies
Last Post
jefjsak
3rd Gen Engine and Drivetrain -> 2003-2007
8
01-15-2015 03:44 PM
Buffalo
3rd Gen High Performance and Accessories (5.9L Only)
1
12-02-2007 08:35 PM
fishin fever
Towing and Hauling / RV
7
02-22-2004 08:32 PM