No power at fuel pump
#1
No power at fuel pump
Two days ago I was driving when suddenly I lost all power. The truck re-started a few times, but it go harder and harder. Luckily I was only a mile from home and it was downhill so I coasted home. I soon realized that my fuel pump (FASS HPFP-95) is getting no power. I then by-passed the wiring of the pump's wiring and relay to see if the pump would run with power going directly to it, sure enough it ran just fine. So I then replaced the relay thinking I would be up and running, but still nothing. I am getting a code of 0629, high voltage at fuel pump. I have been searching endlessly for a short or bad connection somewhere but have found nothing yet. Any help as soon as possible would be much appreciated.
#3
Ended up talking with tech support at fass, they recommended that i just by-pass the pcm (ecm) by cutting the hot wire that goes to it, and re-routing it directly to the fuse box to a spare fuse and put in a 30amp fuse, did it and it all works fine. i suspect that the pcm is being thrown off track by a short somewhere (perhaps at the infamous ac compressor wire that does not have wire loom on it, which i cannot get to due to the fact that the harness is stuck together)
Thread
Thread Starter
Forum
Replies
Last Post
Commatoze
24 Valve Engine and Drivetrain
19
08-08-2004 09:57 PM
amartinson
24 Valve Engine and Drivetrain
0
05-04-2003 01:55 PM