New posts not receiving Admin approval?
#1
New posts not receiving Admin approval?
Over the past month, I've tried to create new posts about what I've been learning/doing as I work on my 1st Gen. I'm new here and understand that there is an admin approval process. I've only had a 25% success rate at my posts being getting approved (1 in 4) - two were repeats of the initial attempt. One was about the Getrag reverse light switch and the other about putting a dodge van step bumper on a 1st gen truck.
I don't participate in too many other forum sites, so I'm not that familiar with Admin approval. Is there something I could be doing differently to get my posts approved?
Thanks!
I don't participate in too many other forum sites, so I'm not that familiar with Admin approval. Is there something I could be doing differently to get my posts approved?
Thanks!
#3
It's my pot and I'll stir it if I want to. If you're not careful, I'll stir your's as well!
I have made many posts over the years and not one of them have required any sort of admin approval. Are you sure that you are clicking on the 'submit' button each time? Did your screen change after you did that?
#5
Registered User
Join Date: Dec 2010
Location: Land of the Toxic Avenger
Posts: 6,769
Received 1,637 Likes
on
1,112 Posts
#6
Yes, it does say that it will be posted pending Admin approval. I'm hosting images via a Google account, like others would do with Photobucket and others, if that makes any difference.
#7
Administrator
I was here during Lary Ellis' (Top) absence as well as some other Admins and personally I have not seen anything under your USER NAME for approval??
I would check to make sure your computer software and browser settings are all working correctly.
-----------
John_P (ADMIN)
I would check to make sure your computer software and browser settings are all working correctly.
-----------
John_P (ADMIN)
Trending Topics
#9
Actually, before I do, is it OK with the Admins here if I post similar things at this site and CumminsForum? I really enjoy both and go back and forth between the two.
Thread
Thread Starter
Forum
Replies
Last Post
JMalone
3rd Generation Ram - Non Drivetrain - All Years
8
04-03-2007 01:20 PM
CTD2001
Suggestions, Comments and Site Questions
8
09-10-2006 08:50 AM