What have people done for filtering the fuel. Still using the factory canister or are you running a inline filter??

when you relocated the lift pump and installed a holley blue or carter fuel pump on the rail with the vulcan line kit?

 

get the fass system and be done

 

I can get the same setup for half the price with a little research. 800 bucks for a fuel setup is too steep for me.

 

the fass that uses the stock fuel filter comes with a napa gold in line filter . the hole set up cost about 450 or so

 

Go to Cummins. Buy a remote head, and an FS1000 or 1001 (one is taller you want the shorter). Install big lines. The filters will contian half again more debris, filters 5 micron at mid 90% (factory '99 only does low 80% at 5 mic) an 99% of 10 micron. Head cost me less then $30. Filters are less then $15.

I dumped the entire factory assembly since I do'nt need heat here.

Randy

 

Thanks randy that's exactly what i was looking for.

 

Actually I THINK, not positive, but the FF1000 &FF1001 are the same but without the water seperator. But I have never inquired about the filter ratings on them. The only advantage is about 1" shorter over all. Cummins can give you a the tech line number for Fleetgaurd and they are willing to give you with the info.

Randy

 

randy thanks for the heads up. i will call them today and get some more info. I will keep you updated.