MD Chapter #33 Good Friday
#18
I have just over 200 miles on it as of today. It's quite a bit louder than I would have though, but from the reading I have done on it that is normal. It catches higher than stock and is every so slightly harder to press (not much).
I get a little chatter from about 1400-1650 or so in some gears, I guess that has to do with matching engine/trans speeds? Anyway, what can I say, I'm a lucky guy to have it! Can't wait to get the Smarty
Here is the flywheel on the bench:
And the whole assembly:
And the stocker
The G-Unit:
(note to all that are planning a swap: TAKE OFF THE SHIFT TOWER FROM THE INSIDE, it is tiiiiiiiight up there on the way out!)
2nd disk:
Up in the ceiling! Doing this without the lift and Cadillac of a tranny jack would have been a friggin JOKE.
I get a little chatter from about 1400-1650 or so in some gears, I guess that has to do with matching engine/trans speeds? Anyway, what can I say, I'm a lucky guy to have it! Can't wait to get the Smarty
Here is the flywheel on the bench:
And the whole assembly:
And the stocker
The G-Unit:
(note to all that are planning a swap: TAKE OFF THE SHIFT TOWER FROM THE INSIDE, it is tiiiiiiiight up there on the way out!)
2nd disk:
Up in the ceiling! Doing this without the lift and Cadillac of a tranny jack would have been a friggin JOKE.
Thread
Thread Starter
Forum
Replies
Last Post
runamuk
Suggestions, Comments and Site Questions
22
12-18-2006 09:49 AM
Original Junior
Natl. and Regional Chapters / Special Events
6
02-02-2004 09:35 PM
ramlovingvet
Other
7
10-27-2002 06:33 PM