I had to crank the truck slightly longer than usual today to start it. Not sure why. I did get a P0336 code which is
Crankshaft Position Sensor A Circuit Range/Performance

Should there be anything to worry about? I figure a few more starts and it will go away. It probably took a second longer than the computer wanted and threw the code.

 

There is a flash for long crank for manual trans trucks, might be worth a trip to dealer to get done. TSB 18-003-06 REV. A

 

I get this code if I accelerate hard, for example from a dead stop. In my case its the TST causing it. Its common with the TST and all I need to do is clear it and its gone. (Until the next time I hit it hard)

 

If it does not go away I will have to take it in. This was the first time it ever took a long time to start. Actually I let it crank for about 3 seconds and stopped. As soon as I tried it again it started right up as usual.

ropnjessi---- Will yours go away by itself if you do not reset it? Or have you not tried?

 

Well as I mentioned before, my code was self induced, once I clear it, I won't see the code again until I nail it fairly hard. I do not have a starting problem though..