Lumbar Support / Air vent
#17
Well, Today I repaired my lumbar per RamGazers directions and it went fine.
The hardest thing to do was get the dang cover unlatched at the bottom.
I changed it a bit, by drilling out the plastic piece that the repaired piece screws into so the repaired piece would seat fully.
The hardest thing to do was get the dang cover unlatched at the bottom.
I changed it a bit, by drilling out the plastic piece that the repaired piece screws into so the repaired piece would seat fully.
#19
Excellent write up, this is a great help. Thanks. The problem I am having concerns the black part in photo 4 from the top of the lumbar 2 post. It's the black plastic mechanism that threads through the side of the seat frame that contains the new eye bolt assembly (which I had to repair as well). My part is broken in half right at the juncture where it threads through the seat frame. I tried to JB Weld it as well as Gorilla Glue, then finally Crazy Glue it with no success? Do you guys know where I can get this piece? A visit to my local Mopar dealer resulted in him trying to sell me the entire rear seat assemble. What a bargain. Thanks for the help.
#20
Registered User
Thread Starter
I'm not sure if they sell it or not. Try www.Rockauto.com
#25
Excellent write up, this is a great help. Thanks. The problem I am having concerns the black part in photo 4 from the top of the lumbar 2 post. It's the black plastic mechanism that threads through the side of the seat frame that contains the new eye bolt assembly (which I had to repair as well). My part is broken in half right at the juncture where it threads through the seat frame. I tried to JB Weld it as well as Gorilla Glue, then finally Crazy Glue it with no success? Do you guys know where I can get this piece? A visit to my local Mopar dealer resulted in him trying to sell me the entire rear seat assemble. What a bargain. Thanks for the help.
The following users liked this post:
Dred Porter (08-01-2019)