Dash brake light
#1
Registered User
Thread Starter
Dash brake light
ive had my abs and brake light on my dash for about 6 months, I changed the rear abs sensor twice, and 2 new hub assemblies with new sensors. Today I took all the connectors at the abs module and greased them, took the harness apart behind the wheel well and greased. And now I only have the brake light on solid. The ebrake is released, a couple months ago I was tracing power to the back sensor and had no power from the harness connector to the rear sensor. So I ran new wire and had power any help would be great, thanks
#3
Registered User
My E-Brake light stays on when I pull the release and the pedal pops up. I have to pull and hold the release again and pull the pedal up with my other hand. Adjusting the cable length worked for a short time but didn't. last for long. Maybe not the same problem you have but worth a try.
Thread
Thread Starter
Forum
Replies
Last Post
Joey-D
3rd Gen Engine and Drivetrain -> 2003-2007
4
12-12-2011 12:52 PM
NoSparkplugs
3rd Generation Ram - Non Drivetrain - All Years
17
05-17-2009 10:36 PM
megajoltman
12 Valve Engine and Drivetrain
7
04-13-2006 02:58 PM