Carli Ball joints break-in
#1
Carli Ball joints break-in
Hey all, I installed upper and lower Carli ball joints 4,000 miles ago and still have some pretty stubborn memory steer about 5-10 degrees either side of steering wheel center. I don't have any memory steer while turning the wheel further than 10 degrees. If I make a sharp turn and let go of the wheel, the steering wheel returns freely to about 5-10 degrees of center in either direction every time. Does anyone have any experience correcting this? Or do I just need to wait it out?
I'm pretty concerned with it because I'm going to be towing a 10,000 lb travel trailer this summer and I think this memory steer is going to pose a big problem towing my trailer safely.
I'm pretty concerned with it because I'm going to be towing a 10,000 lb travel trailer this summer and I think this memory steer is going to pose a big problem towing my trailer safely.
Thread
Thread Starter
Forum
Replies
Last Post
firebill1720
3rd Gen Engine and Drivetrain -> 2003-2007
20
03-05-2010 09:23 AM
bradler
3rd Gen High Performance and Accessories (5.9L Only)
15
01-02-2010 08:34 PM
jmccart
3rd Gen High Performance and Accessories (5.9L Only)
3
12-22-2008 09:25 AM
Berak
3rd Generation Ram - Non Drivetrain - All Years
16
07-21-2008 08:05 PM