Hey all, I was wondering if anyone out there was running the attitude moniter on the a pillar. Do the mounting brackets such as the auto meter setup delete the grab handle? I want to run the moniter on the a pillar but dont want to lose the grab handle as it makes entering the cab much easier.

thanks for the help

 

i have the pillar mount for the attitude. its only 1/2 of the pillar from the dash to the bottom of the grab handle where it uses the bottom hole from the grab handle to secure it with a longer bolt.

 

Beautiful thats what I was figuring cause the pic looked a little too small to take up the whole a pillar. I deffinately dont wanna lose my grab handle because I dont have steps . Id rather have her move fast then get my steps... Maybe im just nuts...

 

NHdodgeman,

Basically you remove the bottom screw hodling the factory A pillar on, install the new color matched pillar and use the longer screw that comes with it. We were the ones that got this all started about a year ago, they look great and make install and removeal real easy. Call us if you need one and we'll be glad to help you.

Mark @ DPPI

 

Pic of mine mounted. I like it ok.

 

Here is my X-monitor for comparison. A little less bulky than the Attitude

 

Hey ramwheelsby4 where did you find your mount to match your int. All I have seen is black

 

Thanks guys those look real good. Ill be ordering that setup sometime later this week I hope.

 

ftltmp

That is the Attitude mount that Edge sells. I bought mine from DPPI. It matches the interior trim exactly.

 

Thanks for the info ramwheelsby4 I will be ordering one of those , very sharp!