Dodge Diesel - Diesel Truck Resource Forums

Dodge Diesel - Diesel Truck Resource Forums (https://www.dieseltruckresource.com/forums/)
-   2nd Gen. Dodge Ram - No Drivetrain (https://www.dieseltruckresource.com/forums/2nd-gen-dodge-ram-no-drivetrain-90/)
-   -   Front Bumper to Accept a Warn 15k Winch - Anyone have plans or know where I can find (https://www.dieseltruckresource.com/forums/2nd-gen-dodge-ram-no-drivetrain-90/front-bumper-accept-warn-15k-winch-anyone-have-plans-know-where-i-can-find-335881/)

bob95065 10-04-2023 09:42 AM

Front Bumper to Accept a Warn 15k Winch - Anyone have plans or know where I can find
 
A friend offered to give me an older Warn 15k winch. It’s on a receiver mount. I want to make a front bumper for the winch. I have a 1997 2500 extended cab truck that I take off road in the deserts of Southern California and Nevada 3 or 4 times a year. A winch could have come in handy many times over the years. I’m going to pick up the winch this weekend. My plan is to go through it this winter and overhaul it so it is in the best condition possible before putting it in a front bumper. Next spring I’ll work on building a bumper for it on my truck.



Does anyone have plans or know of plans for a bumper that can take a large winch? Any info you post is appreciated.

Midnite 10-05-2023 01:40 PM

I've never seen any plans for bumpers, but I've see a lot of Ranch Hand bumpers that have hitch receivers built in.

bob95065 10-05-2023 02:25 PM

I shouldn't have said it's on a receiver mount because it could be confusing. I'm going to take it off the receiver mount and put it in the bumper.

KristaSmalley 10-17-2023 06:29 AM

Any update?

bob95065 10-17-2023 08:35 AM

I picked up the winch and it is pretty beat. I separated it from the receiver mount which weighed more than the winch. I took it part and found the motor to be a lump of rusted steel. I don't think it is salvageable. The gearbox is in good shape since it was packed with grease. It has no rust inside.

I plan on restoring the winch this winter and working on a bumper next spring. I'll probably go with Move since it will save time and I don't think I can buy the steel for what they charge.

I tried to post pictures but there was an error when I did it. I'll try again soon.


SIXSLUG 11-02-2023 08:15 PM

After market bumpers must be gold plated....

There used to be an older 2nd gen running around here with a cable and fairlead where the license plate would normally sit thru the stock bumper...looked like a homemade job, but clean and didn't fatlip the bumper out too far like on the Ford's of the same era...

And if I can offer some advice from an old desert crawler, pack a few good ground anchors, where I used to go out in the Mojave there wasn't much to grab on to...

And mount it good. Nothin funnier than when a winch comes off with the bumper and it's not your truck!![laugh]

Kurt


All times are GMT -5. The time now is 10:32 AM.


© 2024 MH Sub I, LLC dba Internet Brands