mattn124

I recently replaced the steering wheel in my truck, my new one has the radio-controls on it.

My current truck is not setup for this, I'm hoping somebody on here can help me get setup.

I got my replacement steering wheel from an entire column. I noticed that the wiring harness on this column that connects to the clockspring has 2-more wires in it than the one in my truck. I'm assuming these are the wires that go to the radio for the audio controls.

Does anybody know which pins on the actual radio itself are the ones where these wires would connect to? It should be possible for me to just run my own wires to make these work, but I'll need to know which pins to run the wires to.

I'll be digging into the dashboard for other stuff in the future. Was hoping to work this project at the same time.

Thanks in advance for any and all replies.

--Matt