When removing my head I did not see the IAT sensor and pulled the wires from the plug well I put them back in the only way they would go.

So now on start up I now have a P0113 code that I can not clear have re-checked the wires in the connector and they look good. is there a way to check the sensor like with an ohms meter? or check the wiring to see if it is good?

 

I'd just get new one, they aren't really $$$, then you know for sure it's working correctly.

 

Have a look here:

http://www.dodgeram.org/tech/dsl/sensors/IAT/clean.htm

 

Thanks Dr. Evil
I do plan on replacing the sensor but since I messed up the plug I did not want to go get a new one and mess it up or not fix my problem.

I did see on another thread where the input voltage from the ECM is suppost to be 12V.

 

Well got it fixed

My plug was not getting a good connection P0113 code cleared

Now I need to find out if new plugs can be purchased to replace the one on my harness

 

Don't think that you can buy them without buying a harness. If you can't find one, I have an old harness that I can take one from.