Bolt Torque Specs????
 

Ok I got all my parts on the bench to do my clutch saturday morning
BUT
I am having trouble finding torque values for putting it back together.
Hays Book doesn't cover my trans (Please see Sig)
If anybody has an OEM Service book or a really good memory that could help me out on these
Some I got a hunch but need some confirmation
and some I aint gotta clue

Flywheel to Crank bolts 105 FtLb
Press Plate to Flywheel 20 FtLb
Bell housing to block ?? FtLb
Shift Tower bolts ?? FtLb
Input shaft collar bolts ?? FtLbs

any other info that may be helpfull would be greatly appreciated

Just looking through the factory service manual at your NV5600. The Specs your need are:
Shift Tower Bolts- 7-9ftlbs
Input Shaft Retainer-20ftlbs
Clutch Cover Bolts 5/16-17ftlbs
Clutch Cover Bolts 3/8-30ftlbs
Bell housing stuff is confusing without a picture. I can't seem to figure out how to post a pic from my service manual (in adobe) to this page. Sorry.

Thanks
that got most of em
the bell housing stuff I'll jsut use my highly calibrated arm...
for bolts 3/8 and smaller when my elbow pops they are tight
for 7/16 and bigger when my shoulder pops they are tight enough :)

thanks again