valve job
#1
Registered User
Thread Starter
valve job...... one angle or three angle?
I've got a spare 12V I'm going to rebuild, just wondering what other folks have done for the valve job on the head?
Should I do the valves and seats 1 angle? or three angle?
Back in my small block chevy days the three angle valve job was the way to go, not sure what to do on the 12V head. Any advice?
Should I do the valves and seats 1 angle? or three angle?
Back in my small block chevy days the three angle valve job was the way to go, not sure what to do on the 12V head. Any advice?
#2
Registered User
3-angle on the vale is best for airflow as it reduces turbulence. Had it done to a head I recently bought and had worked over. Also known as back-cutting.
Thread
Thread Starter
Forum
Replies
Last Post