12 valve engine stand....
The following users liked this post:
NJTman (02-07-2018)
#17
Registered User
Join Date: Dec 2010
Location: Land of the Toxic Avenger
Posts: 6,770
Received 1,637 Likes
on
1,112 Posts
#18
Registered User
Thread Starter
#19
Registered User
Thread Starter
That would be exactly what I was planning.
#20
Registered User
Thread Starter
weld brace in where blue line is. insert a wedge underneath and it brings it up even...
regarding above mentioned problem... tell me if you all think this will work. Excuse the crudeness of my drawing, hopefully you get the jist...
unbolted the stand and slid it back until it was level. if I put a wedge under it and a metal brace where the blue line is, think it will work? do it to the other side, and there ya go... even steven right?
#21
Registered User
Thread Starter
With the outrigger wheels, it will be wider than the motor is long, so no tipping. that's what I'm going for anyway.
The following users liked this post:
edwinsmith (02-08-2018)
#22
Registered User
Join Date: Dec 2010
Location: Land of the Toxic Avenger
Posts: 6,770
Received 1,637 Likes
on
1,112 Posts
Btw......what's ya got under the tarp???
Inquiring minds..?
#25
Banned
#26
Registered User
Join Date: Dec 2010
Location: Land of the Toxic Avenger
Posts: 6,770
Received 1,637 Likes
on
1,112 Posts
#27
weld brace in where blue line is. insert a wedge underneath and it brings it up even...
regarding above mentioned problem... tell me if you all think this will work. Excuse the crudeness of my drawing, hopefully you get the jist...
unbolted the stand and slid it back until it was level. if I put a wedge under it and a metal brace where the blue line is, think it will work? do it to the other side, and there ya go... even steven right?