DTR #8 November and December 2009 Thread
looks good RJ,
question for you 2nd genners. I am going to put clearance lights on a 95 12V this week. The truck does not have factory lights.
On my truck I found the plug for the clearance lights in my pass side A pillar. is this similar on the 2nd gens? Or will I have to run wires all the way down to another source?
Max
question for you 2nd genners. I am going to put clearance lights on a 95 12V this week. The truck does not have factory lights.
On my truck I found the plug for the clearance lights in my pass side A pillar. is this similar on the 2nd gens? Or will I have to run wires all the way down to another source?
Max
On mine, I would have had to go all the way down to plug under the dash. In the '01s, the harness up the pillar plugged into the same place, but was a different harness depending on which overhead console you had and whether you had clearance lights. I just bought a harness, cut off the plugs, made a new dedicated light harness and connected it to power and ground where it was convenient.
Hit the remote start and nothing? Thought I didn't do it right...about to try again when she started right up.
Since not racing anymore, put muffler back on Saturday. Neighbors never said anything before (leaving everyday at 06:00 in the morning) but two have commented since Sat.... that my CTD sounds quietier!
Hey!! Rob lives.

RJ
I think this year may be the one that kills my batteries. 34 degrees yesterday when I started and it was slower to start. May have to put some $$ in savings for when they die.
good to see ya Rob.
good to see ya Rob.
Is your truck still on the originals? I have been contemplating replacing mine, but so far so good. Haven't slowed down any that I can tell, but they are 5.5 years old.
Welcome back stranger Rob.

..



