heres one I just made for my 95



on the right is one i made for the 01

 

heres mine I found the grill guard at a junk yard for $75 and built the bumper and added the lights and had plans for two smaller fog lights to go just out side of the driving lights. Used 8" C chanel and cut to make the tapper.







same story on the 92 W350 its off of a 00' chevy suburban. took a little tweeking but I think it fits this truck better than the one it was made for.

hope yall dont mind a 1st gen it your section.

 

Those look great - nice work.

 

Hoo boy I gotcha beat on that one. I rear-ended some poor guy in an acura last summer. I had a full tank and a couple bikes in the back and even with the extra following distance I nailed him hard. I was in his back seat, but the truck only had the bumper pushed back a little. No other damage.

I just installed a stock black primer bumper with black trim. It looks pretty good, but Id rather have a road armor if I had that kinda $$$$.

 

Here is my 01 bumper a buddy made for me in exchange for wiring his shop. Hope the pic worked.

 

the day i got-er and the lastone is in wyoming yesterday

 

 

https://www.dieseltruckresource.com/...d.php?t=252445

this is the thread I did on my homemade bumper with pics

 

 

home made

 

here's a link to a 3rd gen bumper I put on my 95. It was pretty cheap and I think it looks better than the old one

http://www.cumminsforum.com/forum/au...en-help-3.html

 

Here is mine:

 

Hey murfman what did you do with the front axil? Is it just a beefed up dana? IT looks cool.

 

its a axle truss for strength. protection and it looks bad ****.

 

where you located and how much to make a bumper like the one on the 01