Dodge Diesel - Diesel Truck Resource Forums

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: fschiola
Showing results 1 to 25 of 500
Search took 0.14 seconds.
Forum: 4th Gen Engine and Drivetrain-2010 and Up
Feb 5, 2022, 10:03 AM
Replies: 1
Views: 928
Posted By fschiola

Flashing check engine light

2016 Ram 2500. I have noticed, especially when it's very cold out that the check engine light, that comes on and stays on at other times until starting, is now flashing while waiting for the grid...
Forum: 4th Gen Engine and Drivetrain-2010 and Up
Apr 17, 2021, 06:47 PM
Replies: 4
Views: 5,665
Posted By fschiola

Well, the problem was with the bottom end of the...

Well, the problem was with the bottom end of the engine, #2 cylinder and required a new engine. My friend is not mechanically inclined and didn’t ask the questions I would have. Touching the buttons...
Forum: 4th Gen Engine and Drivetrain-2010 and Up
Jan 12, 2021, 08:55 AM
Replies: 4
Views: 5,665
Posted By fschiola

Rough idle, knocking sound and white smoke.

I’m looking for advice as to the cause of the above symptoms. The vehicle is a 2018 3500 with about 64,000 miles. There are no active codes when I hooked my code reader to it. The truck was running...
Forum: 24 Valve Engine and Drivetrain
Sep 12, 2020, 09:35 AM
Replies: 14
Views: 1,895
Posted By fschiola

I replaced my Original VP-44 on 2-2017 with...

I replaced my Original VP-44 on 2-2017 with 151,000 miles on it never using any additives. I bought a replacement from Blue Chip Diesel and started having trouble with it about 25,000 miles later.I...
Forum: 24 Valve Engine and Drivetrain
Mar 5, 2020, 07:27 AM
Replies: 0
Views: 834
Posted By fschiola

Stumble and white smoke

I have been experiencing this problem fo a couple of months on my 2000. When under very light throttle, like barely off of idle, and more so when it's cold out, I get a stumble and a lot of white...
Forum: 2nd Gen. Dodge Ram - No Drivetrain
Feb 2, 2020, 08:22 AM
Replies: 40
Views: 74,576
Posted By fschiola

They ones I bought fit in perfectly.

They ones I bought fit in perfectly.
Forum: 2nd Gen. Dodge Ram - No Drivetrain
Dec 1, 2019, 02:36 AM
Replies: 40
Views: 74,576
Posted By fschiola

The picture is the console on a 2000 standard...

The picture is the console on a 2000 standard cab. I’m sure yours is different. The switches that came out had three wires, I matched them except for the yellow, that went to the red lead on the...
Forum: 2nd Gen. Dodge Ram - No Drivetrain
Nov 30, 2019, 07:51 PM
Replies: 40
Views: 74,576
Posted By fschiola

Sorry for the delay. See if the picture helps, if...

Sorry for the delay. See if the picture helps, if not get back to me. I don’t know why it’s sideways. ...
Forum: 4th Gen Engine and Drivetrain-2010 and Up
May 5, 2019, 11:13 AM
Replies: 2
Views: 1,295
Posted By fschiola

I'm curious as to why you want to disable it?

I'm curious as to why you want to disable it?
Forum: 4th Gen Engine and Drivetrain-2010 and Up
May 2, 2019, 12:49 PM
Replies: 4
Views: 2,741
Posted By fschiola

I'm glad that works for you, some can't or won't...

I'm glad that works for you, some can't or won't be able to do without 4wd.
Forum: 4th Gen Engine and Drivetrain-2010 and Up
May 1, 2019, 09:42 PM
Replies: 4
Views: 2,741
Posted By fschiola

Can you tell me what size socket you used on the...

Can you tell me what size socket you used on the hub nut?
Forum: 2nd Gen. Dodge Ram - No Drivetrain
Feb 8, 2018, 12:52 PM
Replies: 40
Views: 74,576
Posted By fschiola

The switches from Digi Key arrived today. They...

The switches from Digi Key arrived today. They are just the ticket. Two of them for $8 including shipping.
Forum: 2nd Gen. Dodge Ram - No Drivetrain
Feb 7, 2018, 11:47 AM
Replies: 40
Views: 74,576
Posted By fschiola

Can you tell us what wires you connected to the...

Can you tell us what wires you connected to the new switch? The colors don't match with the stock wiring colors.
Forum: 12 Valve Engine and Drivetrain
May 8, 2016, 08:30 AM
Replies: 1
Views: 2,887
Posted By fschiola

Front axle u joint replacement

A long time ago, there was a procedure for replacing the front axle u joint using the power steering as a press to remove the hub. I can't find that in a search. Does anyone have a link for that...
Forum: 12 Valve Engine and Drivetrain
Sep 14, 2015, 08:51 AM
Replies: 0
Views: 2,527
Posted By fschiola

Coolant temperature sensor

Can anyone tell me the purpose of this part on my 1997? The scan tool always shows -40 degrees but the temperature gauge on the dashboard acts normally.
Forum: 24 Valve Engine and Drivetrain
Sep 3, 2015, 01:51 PM
Replies: 1
Views: 4,159
Posted By fschiola

Codes P0234 and P0236

Is there anyone that can direct me to a diagnosis on these two codes. All of the searches are showing problems with modified engines and are not helpful with a stock engine. I would like to test, if...
Forum: 12 Valve Engine and Drivetrain
Aug 31, 2015, 05:00 PM
Replies: 2
Views: 948
Posted By fschiola

Here's an update. Both bushings were intact and...

Here's an update. Both bushings were intact and in surprisingly good shape. What I did find however was the shaft had room on the back side of the plate underneath the clip. I had a very thin brass...
Forum: 12 Valve Engine and Drivetrain
Aug 29, 2015, 05:28 PM
Replies: 5
Views: 2,493
Posted By fschiola

I know this is an old thread, but it may help me...

I know this is an old thread, but it may help me with my problem. Can you tell me if you were able to determine what material the bushings were made of, and how long the plastic ones last?
Forum: 12 Valve Engine and Drivetrain
Aug 29, 2015, 04:16 PM
Replies: 2
Views: 948
Posted By fschiola

Movement at the TPS shaft

Is there supposed to be a side to side movement where the cables hook onto the spring? I'm concerned that there is a lot of movement and I'm wondering if this will affect the TPS readings to the ECM...
Forum: 12 Valve Engine and Drivetrain
Apr 15, 2014, 09:06 PM
Replies: 0
Views: 606
Posted By fschiola

PCM source

Can anyone recommend a source for a PCM that will fit a 1997 12 valve.
Forum: Towing and Hauling / RV
Jul 12, 2013, 10:21 PM
Replies: 18
Views: 45,201
Posted By fschiola

Ok, this thread was going the way that I needed...

Ok, this thread was going the way that I needed to answer a question, but ended too soon. I want to put a relay in my 1997 for the trailer hot wire. I'm sure I can find a suitable trigger wire with...
Forum: Towing and Hauling / RV
May 22, 2012, 08:15 PM
Replies: 2
Views: 948
Posted By fschiola

The camper I have covers the bumper. While I...

The camper I have covers the bumper. While I don't always have the camper on, I always have a trailer when it's on. I think I'll cut off the stock box, weld on some flat strap I have, and use hose...
Forum: Towing and Hauling / RV
May 20, 2012, 08:32 AM
Replies: 2
Views: 948
Posted By fschiola

RV plug mount

I have to replace the factory receiver hitch on my 1997. I found a class IV hitch but the problem is it won't have the factory setup for the light plug. I'm looking for options that others have used...
Forum: General Diesel Discussion
Feb 22, 2011, 11:31 AM
Replies: 18
Views: 10,620
Posted By fschiola

I guess what my thoughts are, would it be...

I guess what my thoughts are, would it be possible to contact the owner of the site to see if he would be willing to migrate all of that info to this site? Maybe he doesn't have the time or money to...
Forum: General Diesel Discussion
Feb 21, 2011, 06:29 AM
Replies: 18
Views: 10,620
Posted By fschiola

How would you go about doing that?

How would you go about doing that?
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -5. The time now is 06:16 PM.