|
|
#1 |
|
Registered User
|
Please Help
OK, I am having some crazy things going on, on my truck. I have had my truck to the dealer on,9-20,, 10-23,,11-10, and now just dropped it off today again. I am having issues with the perform service light coming on overhead and the check engine light on in the dash. The crazy thing is that when it happens, the whole dash goes nuts, all the warning lights on the dash come on, the buzzer beeps and the tach and speedo bounce at every beep. This will do it until i shut the truck down. I drove 3 weeks ago to work 7 miles with it doing it. The dealer performed the service,cleaned egr, changed 02 sensors, wrapped exhaust. They just recently thought it was a bad connection at my computer telling it to reset every time it lost connection. didn't work. The change oil light comes on and if i reset it the next time the truck goes haywire it comes on with the perform service and yellow check engine....I am totally lost and I think the dealer is also..The truck runs fine though. Any suggestions or possibilities, or has anyone had this problem? It usually does it in the morning on the first start and then it stops going haywire all day, but the service and check engine light stay on.
__________________
O7.5, 3500,MEGA,6.7,AUTO,4X4 WHITE, SRW ,LARAMIE, CENTER CONSOLE, REAR DVD, GREY LEATHER,, PROCOMP 2.5"LEVEL KIT ,CARLI TRACK BAR, 1"BLOCK REAR, PIONEER Z2 NAV-DVD, 12"SUB, Pro Comp35-12.5-17 at, DTR MEGACAB CLUB MEMBER#231 06 GRAVES CUSTOM CHOPPER 03 YAMAHA GRIZZLY 660 05 YAMAHA YZF-450 DIRT BIKE 02 HARLEY DAVIDSON FATBOY 08 YAMAHA SHO WAVERUNNER |
|
|
|
|
|
#2 |
|
Registered User
|
OK, figured it out for those who read my post. Found out that it was caused by my aftermarket radio. I have a pioneer z2 naz unit and the box that connects to my factory haerness to my pioneer harness, the connection plug to plug was bad. I know this sounds crazy but its true. The stereo harness is connected to the computer somehow and would set off all my alarms and reset my overhead computer every time it would get a bad connection. crazy but true.
|
|
|
|
|
|
#3 |
|
Registered User
|
WOW! How did you figure that out?
__________________
Neil 2007 Ram 2500HD SLT 4x4, Big Hor, 6.7L, 6 speed auto. MODS - K40 - Banks Inter-cooler - Banks Ram Air - Edge Juice w/ Attitude HOT Unlocked - Smarty ME Stack - EGR & DPF Deletes - AFE 5" TBE 6" tip - Optima Batteries - Airdog II - Mag-Hytech Difs and BD trans pans - Amsoil everywhere - 180,000 miles. Save the Ta-Tas sticker. |
|
|
|
|
|
#4 |
|
Registered User
|
The dealer actually figured it out when the truck was there the last time. I told them that it usually did it in the morning on the first start up of the day, when they went out to start the truck in the morning it wouldn't fire. They waited a bit and it started , all the lights on the dash were flashing and the chime beeping so they put the scanner on it and they told me that it said something about a , BUS CONNECTION. They took the center dash apart and fooled with the plug and it would stop and start acting up every time they moved it. I still can't believe it, but i bypassed the connector plug and hard wired it and everything is fine now.....Factory plug and aftermarket sometimes just don't line up i guess...
|
|
|
|
|
|
#5 |
|
Chapter President
Join Date: Feb 2002
Location: Red Deer, Alberta Canada
Posts: 4,236
|
Wow. Good find. I am always leery of aftermarket stuff now with all that electronic control of the new trucks..
__________________
97 2500 4X4 LWB CC SLT Laramie 5spd LSD 3.55. Isspro EV's pyro/boost, #10 Plate, PEAK 3K GSK, AFC Spring, DDP III injectors, S300 Turbo, PEAK IC Boots, TAG III, South Bend 13-1.25" Con FE clutch, SCOTTY II-UNI, MBRP XP 4", KDP Tab, 16° Timing, SS DSS / 03TBK, Roda Deaco PAS. Espar D5WSC heater. B-Quiet sound deadening inside. Dyno 09-2009 401 RWHP / 1050 Ft-lbs '08 2500 4x4 MegaCab Laramie, 6.7, 68RFE, 3.73 LSD, S-67ME POD. Alberta Chapter #5 Prez... PM me for details... |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|