MeanGrn

what is this thing?( did an internet search too) Westberg pump about 2inch long and 1 3/4 around(is this just like a carter or something similar?) trying to get some pics up, i have the stanadyne series 100 lift pump on frame and a westberg lp pump right in front of the stock filter, it says it is a 16psi pump, but my gauge is only reading 10-12 idle(6-8 load) and thats the pressure from the stanadyne i would think unless this walberg is shot and the stanadyne cant push through that dead pump? so that pressure reading would have been the vp alone right?
i dont know how this was set up but i have blown the computer on my vp and want to make sure i have good fuel presure when the new vp goes in, how would i check this pump and if it is pushing fuel? i know my stanadyne is good as i just replaced it last fall, i thinkn my system is good, just need to make sure all pumps work and that the pressure stays up for the new vp

Shovelhead

I think you're refering to a Walbro pump......

The one I'm using is little larger than you've indicated, was installed on the frame rail, and flows >20 psi so I had to add a regulator/bypass in the line.
I used mine to replace the stock lift pump.
Why two pumps?

MeanGrn

nope, not it, having a hard time getting my pics in photobucket so i can post them up, no one seems to know anything about my set up, i have asked alot of guys now including Chip at blue chip etc... he knew what the stanadyne was and said it is a very good pump, but didnt know what the Walberg pump was...?

MeanGrn

fudged up and miss named the pump, it is westberg, out of sonoma cali, gonna call them thursday and see what the deal is, any way to test the pressure?