VP44 puller information
#1
Registered User
Thread Starter
Join Date: Apr 2006
Location: Alabama
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
VP44 puller information
I would like to know who could give me the specs on the injection pump
puller. I had read some had made them from a piece of plate and tapped the holes in them. I mainly need the hole spread I can figure out the rest.
Thanks
TB
puller. I had read some had made them from a piece of plate and tapped the holes in them. I mainly need the hole spread I can figure out the rest.
Thanks
TB
#4
Registered User
Join Date: Apr 2004
Location: St.Paul , MN
Posts: 732
Likes: 0
Received 0 Likes
on
0 Posts
There was a post quite a while ago where a guy took the rear lift ring off the head and drilled a hole in it and tapped it and used a couple sockets for spacers.
Bottom line is that it doesen't take much of a puller. Just be very carefull that you do not drop the nut and washer on the front side and be very careful of the shaft key onthe back side. I used a short magnet and it worked fine.
Bottom line is that it doesen't take much of a puller. Just be very carefull that you do not drop the nut and washer on the front side and be very careful of the shaft key onthe back side. I used a short magnet and it worked fine.
Thread
Thread Starter
Forum
Replies
Last Post
turbo lcc
Performance and Accessories 2nd gen only
15
07-19-2003 01:37 AM