Valve Cover Removal
#1
Registered User
Thread Starter
Valve Cover Removal
Looking to adjust the valves. Is there enough room to pull the valve cover, or do you have to do something special? Doesn't look like there is enough room above the cover in the back.
#2
Registered User
Join Date: Oct 2007
Location: Okotoks, AB
Posts: 1,716
Likes: 0
Received 0 Likes
on
0 Posts
it will go, but you will curse and swear until you figure out the right angles!
you can also cut out some insulation above it to make it easier. also, clean the surrounding area good and knock off any loose debris in the nearby vicinity - you don't want to knock it off and have it fall into the head!
you can also cut out some insulation above it to make it easier. also, clean the surrounding area good and knock off any loose debris in the nearby vicinity - you don't want to knock it off and have it fall into the head!
#3
Registered User
Join Date: Oct 2006
Location: Okotoks AB
Posts: 3,142
Likes: 0
Received 0 Likes
on
0 Posts
Iirc you rock it to the passenger side and slide all the way out forward. Don't worry about the firewall you won't hurt it.
Sent from my Desire HD using Tapatalk
Sent from my Desire HD using Tapatalk
#4
Registered User
Join Date: Aug 2002
Location: Sundre, Alberta
Posts: 1,257
Likes: 0
Received 0 Likes
on
0 Posts
It's a toss up to roll it over to the passenger or drivers side and slide it out.
I find it easier personally to roll it onto the drivers side and slide it towards the front of the truck. It doesn't look like it, but there is enough room.
Jeff
I find it easier personally to roll it onto the drivers side and slide it towards the front of the truck. It doesn't look like it, but there is enough room.
Jeff
Thread
Thread Starter
Forum
Replies
Last Post
cat1713
24 Valve Engine and Drivetrain
6
09-19-2006 04:34 AM