Vacuum pump gear help
Trending Topics
#8
Chapter President
Join Date: Nov 2003
Location: Rural Hall, NC
Posts: 3,807
Likes: 0
Received 0 Likes
on
0 Posts
Sorry LanceD. I dropped the ball on getting the measurements for you. We've been pretty busy getting a truck ready for Pinks All Out this weekend. Just wanted to let you know I haven't forgotten.
#11
Registered User
Thread Starter
Join Date: Oct 2003
Location: Albuquerque, NM
Posts: 1,292
Likes: 0
Received 0 Likes
on
0 Posts
Dang, I can't figure out which one it is. Im trying to replace my vac/ps pump with a dedicated high flow hydro pump to run a bunch of stuff. here are my options for shafts. which one do you think it would be?
#12
oil pump
Sir I have wondered if the case back hoe or lull with the 4 cylinder cummins could have a oil pump that you wont. There may not be enough room in the dodge frame. The 780 case backhoe had oil pump on the end of the crank I think. It had 24 volt starter and a air pump to be used on the air brakes. Manual tack. good luck
#13
Registered User
Thread Starter
Join Date: Oct 2003
Location: Albuquerque, NM
Posts: 1,292
Likes: 0
Received 0 Likes
on
0 Posts
I thought about running one off the front of the crank but there just isn't enough room up there for a pump.
Im going to run one thats 15GPM and a priority valve for the steering. the rest is going for a winch, on board air, and an on board welder. all hydraulic driven
Im going to run one thats 15GPM and a priority valve for the steering. the rest is going for a winch, on board air, and an on board welder. all hydraulic driven
#14
Registered User
vacuum pump gear help
Contact Pete Gould at fixinrams.com. Pete is a major source of remanned vacuum pumps. A hydraulic pump without a large reserve tank and a recirculation circuit will burn itself up before driving 50 miles. There is a belt driven hydraulic pump available from Northern tool that can be turned on and off with an electric clutch like an a/c clutch; flip a switch for hydraulic service, flip a switch to turn it off. Just a suggestion.
Thread
Thread Starter
Forum
Replies
Last Post
jimbo486
1st Gen. Ram - All Topics
14
05-08-2016 06:07 PM
4969joes
12 Valve Engine and Drivetrain
9
03-27-2010 08:58 AM
Jim Dynomite
HELP!
9
02-11-2006 12:56 AM