Ujoints
#1
Registered User
Thread Starter
Join Date: Mar 2002
Location: Ontario
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
Ujoints
Dose anybody have the part number for the correct U-joints for the rear drive shaft on an 03 6 speed short box. The Neapco joint I got I can't get the clips in all the way.I read some where that there is a difference in the width of the cross on some of the u-joints
#2
Registered User
Dont have the part number but I'm pretty sure they are all the same part. Check to make sure one of the needle bearings didnt fall across the cap. I'vehad that happenbefore with the same results.
#3
Registered User
Thread Starter
Join Date: Mar 2002
Location: Ontario
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
The needle bearing wasn't turned over. But to get the clips in I had to grind
10 Thou off of each bearing cap.And I used the 351 u-joint what gives with these drive lines I shouldn't have to grind caps to get the clips in
10 Thou off of each bearing cap.And I used the 351 u-joint what gives with these drive lines I shouldn't have to grind caps to get the clips in
Thread
Thread Starter
Forum
Replies
Last Post
joeel
3rd Gen Engine and Drivetrain -> 2003-2007
2
04-05-2007 01:18 PM
CCOUGHRAN
3rd Gen Engine and Drivetrain -> 2003-2007
11
01-04-2005 10:10 PM