trany shift question
#1
Registered User
Thread Starter
trany shift question
hi
a friends 97 stock trany will shift 1 to 2 fine but does not shift to 3 rd without moving shift lever to N then back to drive then it shifts into 3 rd ?
no slipping when in gear !
just replaced the solinoid pack and gov pres sensor !
recent new tps .
none of these items seem to help ?
any ideas ??
thank you !
a friends 97 stock trany will shift 1 to 2 fine but does not shift to 3 rd without moving shift lever to N then back to drive then it shifts into 3 rd ?
no slipping when in gear !
just replaced the solinoid pack and gov pres sensor !
recent new tps .
none of these items seem to help ?
any ideas ??
thank you !
#2
Registered User
Join Date: May 2010
Location: Dingmans Ferry,PA
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
Aren't the solenoids for OD and TQ lockup?, I hope you guys did the general fluid/filter change and band adj. I don't have my service manual inside, I'l get it in a few hours and check the troubleshooting for 2'nd to 3'rd shift and post it up for you.
#7
Registered User
Join Date: May 2010
Location: Dingmans Ferry,PA
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
All indications are the Gov.assembly or clogged filter,But you changed those. Book suggests looking at your linkage for binding or Adj.issues.... sometimes it's the simple stuff
Thread
Thread Starter
Forum
Replies
Last Post
A_Manke
3rd Gen Engine and Drivetrain -> 2003-2007
4
02-12-2008 11:08 PM