Blackedout1ton

so i finally started to wire my autometer phantom trans temp gauge. anyone know what wire goes where? maybe wire from sender on temp then which pos which ground? right now i put them 1 way and the gauge goes all the way down and when i switch em it maxes out

.boB

The back of the gauge should be clearly marked. Or check the instruction sheet.

cbrahs

back of gauge will read

+ this is switched power
- this is ground
s this goes to sender

Blackedout1ton

is their an actual sender, or just the brass probe?

.boB

The brass probe is the temp sender. It's considerably smaller than the pressure senders.

Blackedout1ton

ya, think ill have to mess around with it some more. somethings not right on my end im sure

Blackedout1ton

well i got er done! about 5 mins and a beer later i realized the ground goes on the top post! whoops, but she works good now, time tuh KEEP THE HAMMER DOWN!