Torque for Torque Converter to Drive Plate (Flex Plate)???
#1
Registered User
Thread Starter
Torque for Torque Converter to Drive Plate (Flex Plate)???
Hello everyone,
I am in the process of installing a Goered triple disk converter to the laminated flexplate and I am not 100% sure of the torque value for the bolts between the torque converter and flexplate. My haynes manual says 22 ft lbs for the 45RE but N/A for the 48RE which I have in the truck.
I am assuming 25 ft lbs along with using locktite. Any confirmation would be appreciated.
Thanks
Scott
I am in the process of installing a Goered triple disk converter to the laminated flexplate and I am not 100% sure of the torque value for the bolts between the torque converter and flexplate. My haynes manual says 22 ft lbs for the 45RE but N/A for the 48RE which I have in the truck.
I am assuming 25 ft lbs along with using locktite. Any confirmation would be appreciated.
Thanks
Scott
Thread
Thread Starter
Forum
Replies
Last Post
cowboykilla235
24 Valve Engine and Drivetrain
5
10-29-2012 08:33 PM