Tone Ring Mod
#1
Registered User
Thread Starter
Join Date: Jul 2004
Location: VA
Posts: 785
Likes: 0
Received 0 Likes
on
0 Posts
Tone Ring Mod
I wanted to advance my timing approx. 2 deg. by doing the tone ring modification. I thought that it was as simple as marking the tone ring, removing four bolts, & slotting the dowel pin hole. Soem that have done this described this as a 15 minute mod. Seemed easy enough, but when I crawled underneath, I could not get good access to the tone ring. Does the radiator shroud need to be removed? The radiator? What else?
#2
Registered User
Join Date: Nov 2004
Location: New Jersey
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
Easy...
The fan shroud is soft rubber. I just unbolted mine from the bottom and wedged it under the fan. Plenty of room. It just looks hard, but it was real easy. Try it and you'll see what I mean.
#3
Registered User
when you take the two nuts off the brackets,pull the shroud back towards the front and start the nuts back on the studs.then let the shroud sit back down on the nuts...plenty of room then.........bama
Thread
Thread Starter
Forum
Replies
Last Post
Dodgezilla
3rd Gen High Performance and Accessories (5.9L Only)
129
11-18-2005 11:43 AM
BossHogg
3rd Gen High Performance and Accessories (5.9L Only)
1
09-30-2005 06:31 PM
Dodgezilla
3rd Gen High Performance and Accessories (5.9L Only)
4
09-30-2005 12:56 PM
BossHogg
3rd Gen High Performance and Accessories (5.9L Only)
3
09-14-2005 09:48 AM