swapping to auto
#1
Registered User
Thread Starter
Join Date: Apr 2005
Location: kentucky
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
swapping to auto
ok guys im gonna pull my 5sp out and put auto in i already have the 47/rh
and flywheel . I know im gonna have to change crossmember have my driveshaft changed tranny cooler lines linkage etc . So is there anything im missing will i need a tps or just put manual valvebobdy in it?
and flywheel . I know im gonna have to change crossmember have my driveshaft changed tranny cooler lines linkage etc . So is there anything im missing will i need a tps or just put manual valvebobdy in it?
#4
Registered User
Join Date: May 2006
Location: Jacksonville, NC
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
all you should need is the bracket that goes on top of the rubber mount for the crossmember. it bolts to the rubber mount and the transmission. are you going to run the heat exchanger that is normally mounted under the turbo on the auto trucks? i have that and the lines. what about the steering column? drive shaft. and yes TPS.
#6
Registered User
Thread Starter
Join Date: Apr 2005
Location: kentucky
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
im not gonna run a stock tranny cooler going with aftermarket one
im gonna have my driveshaft dont at precision driveline
as for the steering colum im not gonna mess with that ill put an aftermarket shifter in the floor
my 5sp will be for sale after swap ill post it on here
forrest if i had the ats valve body i could get away without haveing a tps right?
im gonna have my driveshaft dont at precision driveline
as for the steering colum im not gonna mess with that ill put an aftermarket shifter in the floor
my 5sp will be for sale after swap ill post it on here
forrest if i had the ats valve body i could get away without haveing a tps right?
#7
Registered User
Join Date: Dec 2003
Location: Garrard county, Kentucky
Posts: 3,077
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by OFFDUTYEXPEDITOR
A tow truck on stand-by might also be advisable. After all the posts on these lousy automatics, why would you want to convert over to one???
Eric
Thread
Thread Starter
Forum
Replies
Last Post
O791challenger
24 Valve Engine and Drivetrain
5
07-12-2008 12:53 PM
West Coast
Performance and Accessories 2nd gen only
3
04-18-2008 11:25 AM
Mike Holmen
Performance and Accessories 2nd gen only
23
06-12-2006 03:52 PM
BigBlue
Performance and Accessories 2nd gen only
19
08-10-2005 01:38 AM