stage 2 cp3 dual feed kit
#1
Registered User
Thread Starter
Join Date: May 2006
Location: O.B MS.
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
stage 2 cp3 dual feed kit
need to know what to do with the return lines comming from the pop off valve. do leave it hang or somehow plug the ports??industrial injection cp3 didnt come with any instructions...
#2
Registered User
Join Date: Jan 2002
Location: Southern, Indiana
Posts: 5,352
Likes: 0
Received 0 Likes
on
0 Posts
You probably need to remove the one line and then run a fitting from the filter housing to the other return line. You will probably need a new small section of hose and a couple of hose clamps.
#3
Registered User
Thread Starter
Join Date: May 2006
Location: O.B MS.
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
I dont fully understand? The metal line that comes from the rail pressure relief valve to the fuel filter canister has a T made into it. It T's off the fuel filter canister and then runs to the CP3. What do you do with the line from the relief valve to the filter housing? Do you replace the entire line and block off the filter housing?
#4
Registered User
Join Date: Nov 2001
Location: Heber, Utah
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
When you installed the duel feed line, you should have the cp3 pressure relief valve and banjo bolt, tighten it on to the return line that you just removed. You don't need to take the whole line off. wrap some electrical tape around the end of the banjo bolt and valve, to keep it from coming loose. You don't want to remove the entire line and cap off at the fuel filter. If you do you will have no return fuel.
Thread
Thread Starter
Forum
Replies
Last Post
Jethro6213
3rd Gen High Performance and Accessories (5.9L Only)
19
07-11-2008 11:59 AM
modified03
3rd Gen High Performance and Accessories (5.9L Only)
8
05-26-2008 04:49 AM
streetsmoker
3rd Gen High Performance and Accessories (5.9L Only)
36
02-07-2008 07:16 PM
powerstrokin03
3rd Gen High Performance and Accessories (5.9L Only)
1
02-15-2007 04:29 PM