smart 4.2 and tst stack??
#1
smart 4.2 and tst stack??
I have a smarty 4.2 right now and came across a real cheap tst cr 49 with the adjustable rail pressure and everything What settings should I run the tst on I usually leave my smarty on 9 all the time with no problems. I do have an arsen kit on there now that's not in my sig.
#2
DTR 1st Sergeant
You are probably not going to see much over 2/0-3/0. Do not use any of the torque settings, that only help to drain the rail and smarty is enough down low anyway. You will have to have a modded cp3 to keep from draining the rail.
More than that, I see you do not have a turbo upgrade. You will need that as well.
Watch your rail pressure and egts closely and watch results. If one or the other gets out of whack, you have gone too far and need to turn it down.
Try smarty on sw 7 and tst on 2/0 standard to start.
More than that, I see you do not have a turbo upgrade. You will need that as well.
Watch your rail pressure and egts closely and watch results. If one or the other gets out of whack, you have gone too far and need to turn it down.
Try smarty on sw 7 and tst on 2/0 standard to start.
#6
DTR 1st Sergeant
You could look through the classifieds for now and pick up something used for a decent price... just don't get too big a turbo. Stay around the range of s300 variants with a 62mm inducer... if you could find a garrett gt37 that would be the hot setup.
Thread
Thread Starter
Forum
Replies
Last Post
Totallyrad
Other
33
07-19-2011 04:55 PM
Topper
3rd Gen High Performance and Accessories (5.9L Only)
6
03-03-2008 10:17 AM
D.Wiggs
3rd Gen High Performance and Accessories (5.9L Only)
3
12-27-2006 06:04 PM
mjpalmer
3rd Gen High Performance and Accessories (5.9L Only)
12
05-19-2005 11:34 AM