Size of nut on fan clutch ? 92 CTD in W250
#1
Registered User
Thread Starter
Join Date: Apr 2007
Location: Centerburg OH
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
Size of nut on fan clutch ? 92 CTD in W250
Well I don't have any open end wrenches larger than 1 inch and can't get down in there real well to measure.
So I was hoping someone could tell me the size of this nut before I run to town. It'd be pleasant to get the right part on the first trip just ONCE this weekend.
Thanks,
Brian
So I was hoping someone could tell me the size of this nut before I run to town. It'd be pleasant to get the right part on the first trip just ONCE this weekend.
Thanks,
Brian
#4
Registered User
Not absolutely positive, as I am going on year-ago memory, but I am pretty sure that the clutch requires a 33MM wrench.
I took some 1/8 x 1 strap iron and welded up a real good one, using a clutch-not-on-a-truck as a pattern.
I also made a wrench to hold the drive pulley still.
I took some 1/8 x 1 strap iron and welded up a real good one, using a clutch-not-on-a-truck as a pattern.
I also made a wrench to hold the drive pulley still.
Trending Topics
#9
Registered User
Thread Starter
Join Date: Apr 2007
Location: Centerburg OH
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
Well I rented the wrench set from advanced and they are too big and slip.
I mic'd the new one and it works out to 1.415
Going to just make one but wanted to confirm the nut is lh thread before I yank on it with my home made wrench.
Thanks again,
Brian
I mic'd the new one and it works out to 1.415
Going to just make one but wanted to confirm the nut is lh thread before I yank on it with my home made wrench.
Thanks again,
Brian
Thread
Thread Starter
Forum
Replies
Last Post
Clane
3rd Generation Ram - Non Drivetrain - All Years
5
06-02-2012 03:31 PM