Shift Down at Stop
#1
Registered User
Thread Starter
Join Date: Sep 2006
Location: North Bend, WA
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Shift Down at Stop
Once in awhile, doesn't do it all the time, when I come to a complete stop, my tranny doesn't shift back into 1st. It'll start off in 3rd.
If I go to park, shut down and restart, it'll be back in 1st.
Where should I be looking? Seems like it should be a simple problem.
Thanks
If I go to park, shut down and restart, it'll be back in 1st.
Where should I be looking? Seems like it should be a simple problem.
Thanks
#2
Cummins Guru
Check governor system pressure. Governor pressure should increase / decrease with vehicle speed and must drop below 3 PSI for proper downshift to 1st gear when stopped. Governor solenoid and transducer usually fix this problem. Also check Trans output speed sensor operation. Scan tool would be required to monitor these sensors while driving. Make sure there are no codes stored in the JTEC controller if there is a code P1763 that will put trans into limp in mode 3rd gear only until key off resets the JTEC controller.. There is a flash to correct this problem Erroneous MIL Illumination For P1763 – Trans. Governor Pressure Sensor Volts Too High
Thread
Thread Starter
Forum
Replies
Last Post
Gbuilders
3rd Gen Engine and Drivetrain -> 2007 and up
4
05-08-2007 02:20 PM
slivertruck
3rd Gen High Performance and Accessories (5.9L Only)
25
11-08-2006 08:35 PM
royta
2nd Gen. Dodge Ram - No Drivetrain
7
11-06-2006 08:19 AM