rebuilt tranny wont go forward!
#2
There are so many possibles it isn't easy.
did you disassemble the VB? Are all the check ***** in and in the right places?
Did the rear clutch get put together correct?
Are you planning on doing a pressure check?
did you disassemble the VB? Are all the check ***** in and in the right places?
Did the rear clutch get put together correct?
Are you planning on doing a pressure check?
#3
it has a goearand valve body and tc that was in it before i broke my input shaft. i didn't mess with vb. i just pulled the clutches apart and put new steels and clutches in. but i put the one piece input in so on that piston i put new seals in i dont understand what i did.
#4
Registered User
Join Date: Dec 2007
Location: North Carolina or Kentucky. Take your pick
Posts: 2,738
Received 0 Likes
on
0 Posts
Look at your failed input shaft and note there are three sealing rings (one larger and on rear retainer)on it. Did you put three on yours??
#6
yea i'm not sure what's going on today i pulled it out of the garage and it worked perfect again didn't have time to mess with it or take it for a test drive but it was holding solid in the drive way as in spun the tires on wet concrete before it didnt even move so i will mess around with it 2mro ill let ya know whats going on !
Thread
Thread Starter
Forum
Replies
Last Post
abc4yew
3rd Gen High Performance and Accessories (5.9L Only)
27
07-04-2006 09:15 PM
xxxqme
HELP!
10
08-12-2005 05:12 AM