pump wont prime
#1
Registered User
Thread Starter
Join Date: Jan 2010
Location: Ohio
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
pump wont prime
i know ur thinking, well duh the lift pump is bad, but it worked fine right before i took my IP off to put on a buddies truck....and now when i push the lever to prime the system im not getting any fuel out of the bleed screw....ive hit it with some ether while everything was tight thinking the lift pump was dry or something and the best ive got is a couple bubbles out of the bleed screw when i tried priming after that.....am i doing this right? ive read some write ups and think i'm following them correctly,so is there a chance my lift pump could just go bad like that? any secrets to help prime this thing up?
#3
Registered User
Join Date: Apr 2007
Location: Southern New Jersey
Posts: 4,062
Likes: 0
Received 0 Likes
on
0 Posts
sometimes the cam lobe for the lift pump will be at the highest point when the engine stops and that will not let the manual lever do anything. It will feel semi normal but it wont pump when you move the manual lever. Try just bumping the key and then pumping the manual lever again.
#6
Registered User
Thread Starter
Join Date: Jan 2010
Location: Ohio
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Well lift pump is installed and let me just say...wow. the installation was so simple and it fixed so many problems like choppy idle and better fuel in the top end, everyone should do this if u got the few extra bux lying around.....next will probably be Holley black and my HX35....can't wait
Thread
Thread Starter
Forum
Replies
Last Post
WhiteSport600
3rd Gen Engine and Drivetrain -> 2003-2007
12
10-09-2012 11:40 AM