POD Injector Install
#1
POD Injector Install
I'm getting ready to install some PODS I just bought and I have a quick question. I've never done a set before so I'm trying to take my time and do everything right. The pods seem to have the injector hold down nut on the injector and not able to come off. This seems like it would be hard to line up the little ball that fits in the injector bore. Just want to make sure this is how it goes. Thanks. Any other suggestions would be helpful.
#3
Registered User
#4
Registered User
Join Date: Apr 2007
Location: Southern New Jersey
Posts: 4,062
Likes: 0
Received 0 Likes
on
0 Posts
I have pods in my truck and I was worried about the same exact problem but it is not an issue at all. They go in far enough to engage the alignment ball before the nut hits the threads.
#5
Yep just got them all in I saw that the little ball caught the hole with I sat it in there so I didn't think it mattered.
I just wish I had a stinkin turbo on there so I could go drive it a little bit
I just wish I had a stinkin turbo on there so I could go drive it a little bit
#7
Got an hx40 on the way just trying to figure out how to do the exhaust. I think this adapter will work to let me use a v-band to clamp the big end which is 4" to the back of the turbo and the other end which is 3" with the factory clamp to the downpipe that way I don't have to spend $200 on a down pipe and then a whole 4" exhaust. Do you guys think this will work?
Thread
Thread Starter
Forum
Replies
Last Post
freight train
1st Gen. Ram - All Topics
9
12-06-2011 09:40 AM
BrokeSolid
3rd Gen High Performance and Accessories (5.9L Only)
21
02-03-2009 09:36 AM