Fullsizeyota

I've got a 99 that i'm ditching the 47re for a 4500..

I'll have the tranny, clutch and bellhousing tomorrow.

how do the driveshaft lengths differ from manual to auto??

is the 47re rubber mount the same as a 4500 mount??

which wires on the tranny, or which wires do i need to swap or splice to bypass the park saftey switch so my truck will start once the 4500 is in?

thanks

dieselfuelonly

On my '96 the driveshafts were different lengths. I had the driveshaft that came off the donor truck too, so I'm not sure what the difference was since I just swapped them.

The rubber mount is different. On my 2WD the crossmember was the same - not sure about your 4WD though.

Hopefully this info I give you is correct since you have a 24v and I have a 12v, but I'm not positive... Good luck!