2nd Gen. Dodge Ram - No Drivetrain Discussion for all Dodge Rams from 1994 through 2002. Please, no engine or drivetrain discussion.

No blow through dash vents

Thread Tools
 
Search this Thread
 
Old 05-12-2004, 04:50 PM
  #1  
Registered User
Thread Starter
 
Dargo's Avatar
 
Join Date: Dec 2003
Location: Evansville, IN
Posts: 96
Likes: 0
Received 0 Likes on 0 Posts
No blow through dash vents

I know this may sound stupid, but has anyone else had a problem with the blower blowing only through the floor vent? The A/C works fine (freezes my right foot), but whatever flap moves the air flow from the floor vent to the dash outlets and to the defrost outlets isn't working. I was sort of hoping that someone here could tell me a fix without having to pull out the whole dash and start hunting. Thanks in advance for any pointers!
Old 05-12-2004, 05:13 PM
  #2  
Registered User
Thread Starter
 
Dargo's Avatar
 
Join Date: Dec 2003
Location: Evansville, IN
Posts: 96
Likes: 0
Received 0 Likes on 0 Posts
two flap motors

I looked above the throttle pedel and there are two flap motors. One has a yellow line to it. If I pull down on the lever coming out of it I get the air through the dash vents where I want it. There is another one to the right (passenger side) of that motor that has a red line going to it. If I pull the red line off, I can feel a vacuum from that motor. If I pull the yellow line off, I do not feel a vacuum anywhere.
Old 05-12-2004, 08:03 PM
  #3  
Registered User
 
infidel's Avatar
 
Join Date: Dec 2003
Location: Montana
Posts: 14,672
Likes: 0
Received 9 Likes on 9 Posts
Since you have vacuum you can eliminate that possibility. My bet is the selector switch is on the fritz.
Old 05-13-2004, 10:56 AM
  #4  
Registered User
 
INJECTOR JACK's Avatar
 
Join Date: Nov 2002
Location: South Surrey,B.C. Canada!
Posts: 360
Likes: 0
Received 0 Likes on 0 Posts
heater vents

My was the yellow line servo it had a hole in the diagram. Thats the one that controls the dash vent
Old 05-13-2004, 12:13 PM
  #5  
Registered User
 
Palmetto_kid's Avatar
 
Join Date: Sep 2001
Location: Sweeny, Texas
Posts: 772
Likes: 0
Received 0 Likes on 0 Posts
I had the exact same problem on my '97. THis problem led me to this board too!! It took me like 1 week to get an answer to my post too! but that was back when we only had 145 members.

I went down to my local dodge *******, and bought the little vacuum actuator that controls the dash vents. Swapped it out, and no problems.

I did the same as you. I could reach under the dash and pull the lever down, and it would hold. But the daiphram had a hole in it, and could not pull it down.

good luck!
PHillip
Old 05-13-2004, 07:27 PM
  #6  
Registered User
 
Joseph H. Smith's Avatar
 
Join Date: Jan 2004
Location: From Indiana work in Panama
Posts: 136
Likes: 0
Received 0 Likes on 0 Posts
I had the same problem. The control was leaking and did not have enough seal to pull it but if you pulled it manually it would hold. Bought and replaced it. Easy job not an inexpensive part.
Old 05-14-2004, 12:03 PM
  #7  
Registered User
 
BoldtsWagon's Avatar
 
Join Date: Jun 2002
Location: WA state
Posts: 105
Likes: 0
Received 0 Likes on 0 Posts
https://www.dieseltruckresource.com/...threadid=30705
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
hognutz
3rd Generation Ram - Non Drivetrain - All Years
14
09-15-2009 06:53 PM
grd238
3rd Generation Ram - Non Drivetrain - All Years
4
07-17-2009 01:14 PM
eightball
3rd Gen Engine and Drivetrain -> 2003-2007
4
04-06-2006 08:30 PM
243
2nd Gen. Dodge Ram - No Drivetrain
19
04-11-2005 09:55 AM
Eskimo
12 Valve Engine and Drivetrain
10
11-17-2004 10:02 AM



Quick Reply: No blow through dash vents



All times are GMT -5. The time now is 12:39 AM.