New Guy in Colorado
#1
Registered User
Thread Starter
Join Date: Aug 2009
Location: Denver Colorado
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
New Guy in Colorado
Howdy to everyone, Im Clyde from Colorado, Some of you may know me as a moderator on Colorado4x4.org. Anyway, Long time mopar owner, long time lusting after a cummins, and within the last week, livin the dream. I just did a conversion with my 77 D-200, grafted onto a 93 W-250/350 chassis, not sure which it is, but it does have a 60 under the front, which leads me to believe it was a one ton. Started my project a week ago today, and driving it now. I really had no idea what I was getting into, but fortunately, it went a lot easier than i had thought it would, only the wiring gave me any real problem, and even that wasnt to bad.. Found many helpful posts here, and sure I will find many more. Thanks.
#4
Registered User
Thread Starter
Join Date: Aug 2009
Location: Denver Colorado
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
thanks guys. I will try and get some pics up soon, in the conversion section. It made its maiden highway run today, ran out good to about 80, but sounded like it was wound pretty tight there, even with the OD, and 3.54s. Unfortunately no tach, so didnt wanna push it to hard. I have some off idle issue going on that I need to try and figure out, just wont come up like I know it should.
Thread
Thread Starter
Forum
Replies
Last Post