bigair

I'm now half way through putting on new exhaust on only to find out I dont have enough pipe to get to back of truck. If I put entire system together the large radius thats supposed to go over the axle is about a foot or more forward of axle. I think the staight piece that goes between down pipe and muffler is too short, anybody with this system if you could take a measurement and tell me what you get. thanks

P.J

Is it possible that you were shipped the SWB kit?

Other than that I can't help. Heard nothing but GOOD about the warpspeed systems.
Curious to hear the results. Sucks your stuck at the shop.

bigair

I didn't know their was a shor wheel base cummins.

P.J

There isn't?
Run it however you can, give them a call in the morning. they should be able to give you numbers (measurements) for all the pieces they were supposed to send you. You figure out the wrong one, they send you out a new one priority. (or at least thats the way it should go).
?

bigair

thats the way I hope its going to go, but it will be friday and it did take well over a week for it to get here using "3 day" last time, probably wont get here till middle next week, then i get to start all over again. atleast while i wait my truck sounds really mean with nothing more than a down pipe and a 3 foot straight pipe .

phox_mulder

Regular cab shortbed(?), Quad Cab short bed.
Regular cab longbed, Quad Cab long bed.

Some might be interchangeable, like Quad short and regular cab long.


phox

newriverSpecon

No reg cab swb. The rest are correct though.

Randy