How to mount quad RP guage
08-30-2007, 06:08 PM
#3
Registered User
Join Date: Aug 2005
Location: Minnesota
Posts: 1,303
Likes: 0
Received 0 Likes
on
0 Posts
Maybe you could use double sideded stick tape and put the gauge next to the A-Pillar?
I've been thinking about a place to install one aswell, I thought there was a gauge holder out?
I've been thinking about a place to install one aswell, I thought there was a gauge holder out?
08-30-2007, 07:28 PM
#4
Registered User
I fed the cable through the hole where the cupholder light is supposed to go. Mine didnt come with the light group so theres plenty of room to feed all kinds of cables and tubing through that hole.
I then mounted the RP gauge, with the supplied velcro, to the left of the hole (butted up against the left part of the center console) and just about flush with the front face of the dash.
The cable is not very visible at all and I plan to use the area to the right of the RP gauge to mount a couple westach combo gauges in their bullet mounts.
I then mounted the RP gauge, with the supplied velcro, to the left of the hole (butted up against the left part of the center console) and just about flush with the front face of the dash.
The cable is not very visible at all and I plan to use the area to the right of the RP gauge to mount a couple westach combo gauges in their bullet mounts.
Thread
Thread Starter
Forum
Replies
Last Post
J10495T
3rd Gen High Performance and Accessories (5.9L Only)
1
09-21-2011 04:07 PM
chw
3rd Gen High Performance and Accessories (5.9L Only)
2
12-25-2006 04:30 PM
ckennedy
3rd Gen Engine and Drivetrain -> 2003-2007
2
11-15-2004 05:35 PM