Map sensor
#1
Registered User
Thread Starter
Join Date: Mar 2008
Location: Montana
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Map sensor
truck seem to get quiet during acceleration 1200-1800 RPM otherwise runs normal I didn't get a error code till I disconnected Quadzilla M3. Then I produced code 0237 (map sensor voltage too low) cleared code and left Quadzilla disconnected , seems to run normally. any ideas as to my problem I've been waiting a while before reconnecting Chip
#3
Registered User
Thread Starter
Join Date: Mar 2008
Location: Montana
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Why did disconnecting the box also make the truck run correctly under acceleration, do I have box problems? or is the box magnifying another problem?
#4
Registered User
Join Date: Jun 2006
Location: Thamesford, Ontario Canada
Posts: 1,288
Likes: 0
Received 0 Likes
on
0 Posts
Check for any little corrosion in your MAP Sensor plugs. Check for bad wiring, and check the plug connectors on each end and make sure they are getting full contact once plugged in. I had MAP Sensor Voltage Too Low back in the spring, ended up being a little bit of blue (corrosion) on one of the contacts on my XZT+ Plug. Once I plugged the stock MAP Sensor back into the Map Sensor itself, there was no corrosion there to cause resistance problems, truck ran normal.
Thread
Thread Starter
Forum
Replies
Last Post
scottboy69358
24 Valve Engine and Drivetrain
12
07-04-2013 02:05 AM
Moobesor
3rd Gen High Performance and Accessories (5.9L Only)
4
02-23-2008 09:57 AM
Booost Almighty
Performance and Accessories 2nd gen only
4
01-01-2006 01:41 PM