Mach 4 Install Help

Reply Subscribe

Thread Tools

Search this Thread

05-13-2010, 09:05 PM

CODODGE2500MAN

Chapter President

Thread Starter

Join Date: Oct 2004

Location: Highlands Ranch, Colorado

Posts: 978

Likes: 0

Received 0 Likes on 0 Posts

Mach 4 Install Help

Welp, now that I got the stupid CKP sensor fixed, I'm heading toward the Mach 4's...

Anyone want to come help that knows how to do it? I'll be in Grand Rapids, MI until December 2010 and then I'll be back in the Denver, CO area...

Or, anyone know of a shop (& how much they'll charge/should charge?) near either Grand Rapids or Denver?

Reply Like

05-14-2010, 09:26 AM

HOHN

Registered User

Join Date: Apr 2003

Location: Cummins Technical Center, IN

Posts: 6,564

Likes: 0

Received 6 Likes on 5 Posts

Sorry, I'm not even close to you. Want to swing through Indiana?

Reply Like

05-14-2010, 12:23 PM

J Lent

Banned

Join Date: Apr 2007

Location: East Millsboro, PA.

Posts: 3,309

Likes: 0

Received 1 Like on 1 Post

One hour shop rate time, 1 1/2 hours if they are slow. About $75-$100 to install them. Shoot by PA, I'll do them.

Reply Like

05-16-2010, 10:26 PM

DodgenIt

Registered User

Join Date: Apr 2007

Location: SLC, Ut. 4,200 ft.

Posts: 990

Likes: 0

Received 0 Likes on 0 Posts

Injector swap isnt too hard on its own.
Look it up on you tube, I watched a few videos on there and went at it and turned out good after about 2 hours.