Injectors Or Programmer
#1
Injectors Or Programmer
Does Anyone Recomend Anything For One Of These To I Allready Have A Edge E-z Which Works All Right But Im Not Real Crazy About Electics And Wiring I Also Airaid Intake And 5 Inch Straights
#3
Registered User
Join Date: Jun 2005
Location: Nebraska
Posts: 2,452
Likes: 0
Received 0 Likes
on
0 Posts
A downloader or control module will both give you more bang for the buck than injectors. Also, downloader = 5-6 minutes, control module = 30-60 minutes, injectors = several hours and cannot be changed back easily.
#4
Banned
Definatly a programer. You can get more power from a programer then you can with just injectors. A programer is less then half the cost of injectors, and many programers have a ton of features, for example on my bullydog you can:
remove tq management
add low end power
read codes
enable ide control with cruise control buttons
adjust how long your accessories stay on after you remove the key
enable the use of fog lights and brights at the same time
enable/disable auto door looks, seat belt chime etc...
remove tq management
add low end power
read codes
enable ide control with cruise control buttons
adjust how long your accessories stay on after you remove the key
enable the use of fog lights and brights at the same time
enable/disable auto door looks, seat belt chime etc...
#7
Registered User
Join Date: Jun 2004
Location: Edmonton, Alberta
Posts: 1,245
Likes: 0
Received 0 Likes
on
0 Posts
Agreed, on a 12v or 24v....on a CR your looking closer too 2-4 hrs, depending on experiance. And we do not replace the injector on our trucks, we pull the injector, swap nozzles, and replace injector.....a set of injectors for our machines is close too the 3000 mark (stockers). Plus the cost of nozzles!!
Trending Topics
#8
Registered User
Join Date: Jun 2004
Location: Edmonton, Alberta
Posts: 1,245
Likes: 0
Received 0 Likes
on
0 Posts
Agreed, on a 12v or 24v....on a CR your looking closer too 2-4 hrs, depending on experiance. And we do not replace the injector on our trucks, we pull the injector, swap nozzles, and replace injector.....a set of injectors for our machines is close too the 3000 mark (stockers). Plus the cost of nozzles!!
Thread
Thread Starter
Forum
Replies
Last Post
darrenG
Performance and Accessories 2nd gen only
8
06-21-2005 10:24 PM