K RUSSO

Does Anyone Recomend Anything For One Of These To I Allready Have A Edge E-z Which Works All Right But Im Not Real Crazy About Electics And Wiring I Also Airaid Intake And 5 Inch Straights

Mav

Id get a programmer first

omaharam

A downloader or control module will both give you more bang for the buck than injectors. Also, downloader = 5-6 minutes, control module = 30-60 minutes, injectors = several hours and cannot be changed back easily.

acook

Definatly a programer. You can get more power from a programer then you can with just injectors. A programer is less then half the cost of injectors, and many programers have a ton of features, for example on my bullydog you can:
remove tq management
add low end power
read codes
enable ide control with cruise control buttons
adjust how long your accessories stay on after you remove the key
enable the use of fog lights and brights at the same time
enable/disable auto door looks, seat belt chime etc...

Floorman

injectors take less than an hour to install . however boxes give you just as much power and are easier to install.

acook

trust me, a first time injector install will NOT take less then an hour.

ramtd02

Agreed, on a 12v or 24v....on a CR your looking closer too 2-4 hrs, depending on experiance. And we do not replace the injector on our trucks, we pull the injector, swap nozzles, and replace injector.....a set of injectors for our machines is close too the 3000 mark (stockers). Plus the cost of nozzles!!

ramtd02

Agreed, on a 12v or 24v....on a CR your looking closer too 2-4 hrs, depending on experiance. And we do not replace the injector on our trucks, we pull the injector, swap nozzles, and replace injector.....a set of injectors for our machines is close too the 3000 mark (stockers). Plus the cost of nozzles!!